| Abstract: | Four ethylene vinyl acetate (EVA) co-polymers with different vinyl acetate (VA) contents (9–20 wt%) were treated with corona discharge to improve their adhesion to polychloroprene (PCP) adhesive. The thermal properties of the EVAs decreased as their VA content increased, caused by a decrease in crystallinity. The elastic and viscous moduli of the EVAs decreased and the temperature and modulus at the cross-over between these moduli decreased with increasing VA content. Contact-angle measurements (water), infrared spectroscopy (ATR-IR), X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM) were used to analyse the surface modifications produced in the corona-discharge-treated EVAs. The corona discharge treatment produced improved wettability and created roughness and oxygen moieties on the EVA surfaces. The higher the VA content and the higher the corona energy, the more significant modifications were produced on the EVA surface. The VA content also affected the T-peel strength values of treated EVA/polychloroprene + isocyanate adhesive joints, as the values increased with increasing VA content. Mixed failure modes (interfacial + cohesive failure in the EVA) were obtained in the adhesive joints produced with corona discharge treated EVAs containing more than 9 wt% VA. The accelerated ageing of the joints did not affect the T-peel strength values, but the locus of failure in most cases became fully cohesive in the EVA, likely due to the higher extent of curing of the adhesive. |
