Non-newtonian thermal analysis of an EHD contact lubricated with MIL-L-23699 oil

A thermal and non-Newtonian fluid model under elastohydrodynamic lubrication conditions is proposed, integrating some particularities, such as the separation between hydrodynamic and dissipative phenomena inside the contact. The concept of apparent viscosity is used to introduce the non-Newtonian behaviour of the lubricant and the thermal behaviour of the contact into the Reynolds equation, acting as a link element between the hydrodynamic and dissipative components of the EHD film, independently of the rheological and thermal models considered. The apparent viscosity enables the application of the rheological model better adapted to each lubricant, without appealing to special formulations of the EHD problem.The Newton–Raphson technique is used to obtain the lubricant film geometry and the pressure distribution inside the EHD contact. The shear stresses developed in the fluid film are evaluated assuming the non-linear Maxwell rheological model. The surfaces and lubricant temperature distributions are determined using the simplified Houpert's method, applied to the inlet contact zone, and the thermal method proposed by Tevaarwerk is applied in the high pressure contact zone.The non-Newtonian thermal EHD model is applied to the analysis of a contact lubricated with MIL-L-23699 oil. Significant results are obtained for the centre and minimum film thickness, for the inlet shear heating and film thickness reduction factor (φ_T), for the temperature rise of the lubricant and of the surfaces and for the friction coefficient inside the contact, considering wide ranges of the operating conditions (maximum Hertzian pressure, inlet oil temperature, rolling speed and slide-to-roll ratio).Finally, the numerical traction curves determined are compared with the corresponding experimental results, showing very good correlation.