首页 | 本学科首页   官方微博 | 高级检索  
     

射频磁控溅射制备(In,Co)共掺ZnO薄膜的电学和磁学性质
引用本文:刘芬,代明江,林松盛,石倩,孙珲. 射频磁控溅射制备(In,Co)共掺ZnO薄膜的电学和磁学性质[J]. 工程科学学报, 2021, 43(3): 385-391. DOI: 10.13374/j.issn2095-9389.2020.01.11.002
作者姓名:刘芬  代明江  林松盛  石倩  孙珲
作者单位:1.山东大学山东省光学天文与日地空间环境重点实验室,空间科学与物理学院,威海 264209
基金项目:广东省现代表面工程技术重点实验室课题资助项目;国家自然科学基金资助项目;山东大学(威海)青年学者未来计划资助项目;山东省自然科学基金资助项目;中国博士后基金面上资助项目
摘    要:(In, Co)共掺的ZnO薄膜(ICZO薄膜)在100 ℃下通过射频(RF)溅射沉积至玻璃基板上。沉积过程采用In、Co、Zn三靶共溅射。通过调节靶功率,获得了不同In含量的ICZO薄膜。研究了不同In含量下薄膜电学性质和磁学性质的变化。分别使用扫描电子显微镜(SEM)、高分辨透射电子显微镜(HR-TEM)、原子力显微镜(AFM)、电子探针扫描(EPMA)、X射线衍射仪(XRD)、霍尔测试(Hall measurement)和振动样品磁强计(VSM)对薄膜的成分、形貌、结构、电学特性和磁学特性进行了表征和分析。详细分析了薄膜中载流子浓度对磁学性质的影响。实验结果表明,随着薄膜中In含量的提高,薄膜中载流子浓度显著提高,薄膜的导电性得到优化。所有的薄膜均表现出室温下的铁磁特性。与此同时,束缚磁极化子(BMP)模型与交换耦合效应两种不同的机制作用于ICZO半导体材料,致使薄膜的饱和磁化强度随载流子浓度发生改变,并呈现在三个不同的区域。 

关 键 词:稀磁半导体   ICZO   射频磁控溅射   束缚磁极化子   磁学性质
收稿时间:2020-01-11

Electrical and magnetic properties of(In,Co)co-doped ZnO films deposited using radio frequency magnetron sputtering
LIU Fen,DAI Ming-jiang,LIN Song-sheng,SHI Qian,SUN Hui. Electrical and magnetic properties of(In,Co)co-doped ZnO films deposited using radio frequency magnetron sputtering[J]. Chinese Journal of Engineering, 2021, 43(3): 385-391. DOI: 10.13374/j.issn2095-9389.2020.01.11.002
Authors:LIU Fen  DAI Ming-jiang  LIN Song-sheng  SHI Qian  SUN Hui
Affiliation:1.Shandong Key Laboratory of Optical Astronomy and Solar-Terrestrial Environment, School of Space Science and Physics, Shandong University, Weihai 264209, China2.Key Lab of Guangdong for Modern Surface Engineering Technology, National Engineering Laboratory for Modern Mate-rials Surface Engineering Technology, Guangdong Institute of New Materials, Guangzhou 510651, China3.College of Materials Science and Engineering, Jilin University, Changchun 130012, China
Abstract:Diluted magnetic semiconductors (DMSs) have attracted much attention in recent years due to their dual control of charge and spin degrees of freedom in carriers. Potential applications of DMSs include spin light-emitting diodes, spin field-effect transistors, magnetoresistance random access memory, and ultrafast optical switches. However, the Curie temperature (Tc) of most DMSs below ambient temperature limits the efficiency of these devices. Thus, the biggest challenge for developing DMS materials has been producing host materials that exhibit ferromagnetic behavior above ambient temperature. A series of theoretical simulations and experiments show that the Tc value of ZnO-based DMSs could satisfy this requirement. Incorporation of selective transition metal elements (e.g., Fe2+, Co2+, Ni2+, and Mn2+) has been confirmed as an effective way to enhance the magnetic properties of ZnO. In the present research, (In, Co) co-doped ZnO (ICZO) films were deposited by radio frequency sputtering at 100 ℃ on a glass substrate. The sputtering process was performed through In, Co, and ZnO co-sputtering. The presence of ICZO films has been adjusted by changing the target sputtering power. The variation of electric and magnetic properties of the film was studied with different In content. The composition, morphology, structure, electric and magnetic properties of films were characterized by field emission scanning electron microscopy, high-resolution transmission electron microscopy, atomic force microscopy, electron probe microanalyzer, X-ray diffractometer, Hall effect analysis, and vibrating sample magnetometer. The effect of carrier concentration on the magnetic properties of the film was analyzed extensively. These results show that, in the presence of In, the carrier concentration increases, thereby optimizing films’ conductivity. All the films present ferromagnetic behavior at room temperature. Besides, with an influence of bound magnetic polaron model and carrier-mediated exchange mechanisms on the film’s saturation magnetization, carrier-concentration dependent behavior can be expressed in three different regions. 
Keywords:
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《工程科学学报》浏览原始摘要信息
点击此处可从《工程科学学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号