| 充电器上盖成型工艺分析与注射模设计 |
| |
| 引用本文： | 奚建胜.充电器上盖成型工艺分析与注射模设计[J].模具工业,2008,34(5):56-60. |
| |
| 作者姓名： | 奚建胜 |
| |
| 作者单位： | 湖北汽车工业学院,材料工程系,湖北,十堰,442002 |
| |
| 摘 要： | 用Moldflow对充电器上盖成型工艺进行分析,对熔体填充、冷却、流动及塑件翘曲进行模拟,预测塑件成型过程中可能出现的缺陷,确定合理的熔体注射时间、温度、压力等成型工艺参数,优化冷却水道直径和浇注系统尺寸,降低模具加工成本,缩短了模具制作周期。
|
| 关 键 词： | 充电器上盖 模拟分析 注射模 |
| 文章编号： | 1001-2168(2008)05-0056-05 |
| 修稿时间： | 2007年11月23 |
Analysis on forming process and design of injection mould for the upper cover of charger |
| |
| XI Jian-sheng.Analysis on forming process and design of injection mould for the upper cover of charger[J].Die & Mould Industry,2008,34(5):56-60. |
| |
| Authors: | XI Jian-sheng |
| |
| Abstract: | By The potential defects during the forming process of the upper cover of a charger were predicted based on an analysis on the forming process by using Moldflow and on the simulation on the filling,cooling,flowing of melt plastic and warpage of finished product.The technological parameters,including the injection time,temperature,pressure,cooling water channel layout and diameter, feeding system dimensions,were optimized that helps lower the manufacturing costs and shorten the cycle of making. |
| |
| Keywords: | upper cover of charger simulation analysis injection mould |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
