Analysis of shear stress distribution in pushout process of fiber-reinforced ceramics |
| |
| Affiliation: | 1. Resident, Department of Conservative Dentistry, Wonju Severance Christian Hospital, Wonju College of Medicine, Yonsei University, Wonju, Republic of Korea;2. Assistant Professor, Department of Orthodontics, Wonju Severance Christian Hospital, Wonju College of Medicine, Yonsei University, Wonju, Republic of Korea;3. Professor, Department of Conservative Dentistry, Gangnam Severance Hospital, College of Dentistry, Yonsei University, Seoul, Republic of Korea;4. Professor, Department of Conservative Dentistry, Wonju Severance Christian Hospital, Wonju College of Medicine, Yonsei University, Wonju, Republic of Korea;5. Research Professor, Institute of Lifestyle Medicine, Wonju College of Medicine, Yonsei University, Wonju, Republic of Korea;6. Associate Professor, Department of Conservative Dentistry, Wonju Severance Christian Hospital, Wonju College of Medicine, Yonsei University, Wonju, Republic of Korea;1. Department of Mechanical and Electro-Mechanical Engineering, National Sun Yat-Sen University, Kaohsiung 80424, Taiwan;2. Department of Power Mechanical Engineering, National Taitung College, Taitung 95045, Taiwan;1. Laboratory of Timber Construction (IBOIS), School of Architecture, Civil and Environmental Engineering (ENAC), École Polytechnique Fédérale de Lausanne (EPFL), Lausanne, Vaud, Switzerland;2. Department of Civil and Environmental Engineering, University of California Los Angeles (UCLA), Los Angeles, CA, United States;3. The National Centre of Competence in Research (NCCR) Digital Fabrication (DFab), Swiss Federal Institute of Technology in Zurich (ETHZ), Zurich, Zurich, Switzerland;1. NASA Glenn Research Center, Materials and Structures Division, Cleveland, OH 44135, USA;2. Ohio Aerospace Institute, Cleveland, OH 44135, USA |
| |
| Abstract: | The interfacial shear stress distribution of a thin specimen of SiC fiber-reinforced glass matrix composite (fiber volume fraction of 0.1, 0.5 and 0.7) during a fiber pushout process was subjected to finite element analysis using a three concentric axisymmetrical model which consisted of fiber, matrix, and composite. A stress criterion was used to determine interface debonding. Effects of thermally-induced stress and a post debond sliding process at the interface were also included in the analysis. The analytical result showed that shear stress near the specimen surface was introduced during the specimen preparation process. Before the interfacial debonding, the distribution of shear stress during the pushout test was affected by the existence of thermally-induced stress in the specimen. The interfacial shear debonding initiated ≈ 30 μm below the pushing surface and the sliding at the debonded interface proceeded in the direction of both the pushing surface and back surface from the peak shear position; the debonding from the back surface initiated just before the complete debonding of the interface. The pushout load-displacement curve near the origin was straight, however, after the existence of interface sliding at the debonded interface, the curve exhibited non-linearity with the increase in applied load up to the complete debonding at the interface. This debonding process was essentially independent of the fiber volume fraction. The results indicate that the total of thermally-induced stress in the specimen and shear stress distribution generated by applied load are important for the initiation of debonding and the frictional sliding process of the thin specimen pushout test. |
| |
| Keywords: | |
| 本文献已被 ScienceDirect 等数据库收录！ |
|
