Colour in short-term thermo-mechanically densified veneer of various wood species

Effect of short-term thermo-mechanical (STTM) densification temperature and pressure on the surface colour of veneer of four wood species—alder (Alnus glutinosa Gaertn.), beech (Fagus sylvatica L.), birch (Betula verrucosa Ehrh.), and pine (Pinus sylvestris L.) as well as possible correlations among all determined colour parameters (L*, a*, b*, h, C* and ?E) were investigated. Veneer sheets were densified at temperatures of 100, 150 or 200 °C and pressures of 4, 8 or 12 MPa for 4 min. The results were compared with those of non-densified veneers. The colour change of the samples was evaluated by CIEL*a*b* and L*h*C* colour co-ordinate systems. The results indicated: the temperature and pressure of densification affected to a big extent the colour of the veneer samples, with the effect of densification temperature being more evident than that of pressure. After the densification process, the veneers darkened. Colour changes are most pronounced at the highest densification temperature of 200 °C and very small at the lower temperatures of 100 and 150 °C for all investigated wood species. The change in a* is more pronounced than the change in L* or b*. In general, alder and birch veneer samples are characterized by the highest values of total colour difference followed by pine and beech samples among the four species. The quadratic models can be used for the prediction of surface colour in the densification process. The results of this study indicate that it is possible to govern surface colouration of wood veneers during densification process on an industrial basis.