| V形件弯曲凹模最小深度的计算 |
| |
| 引用本文： | 彭炎荣,江荧,罗文波,彭定. V形件弯曲凹模最小深度的计算[J]. 模具工业, 2005, 0(4): 21-23 |
| |
| 作者姓名： | 彭炎荣 江荧 罗文波 彭定 |
| |
| 作者单位： | 1. 湖南铁道职业技术学院,湖南株洲,412002
2. 湘潭大学,湖南湘潭,411105 |
| |
| 摘 要： | 分析了V形件弯曲过程中变形区与非变形区的变化规律,建立了计算凹模最小深度的公式,并通过数值实例,讨论了工件尺寸与凹模圆角半径对弯曲凹模最小深度的影响。
|
| 关 键 词： | V形弯曲 凹模深度 变形区 非变形区 |
| 文章编号： | 1001-2168(2005)04-0021-03 |
| 修稿时间： | 2004-10-30 |
Calculation of the Minimum Depth of the Bending Female Die for Vee Parts |
| |
| PENG Yan-rong,JIANG Ying,LUO Wen-bo,PENG Ding. Calculation of the Minimum Depth of the Bending Female Die for Vee Parts[J]. Die & Mould Industry, 2005, 0(4): 21-23 |
| |
| Authors: | PENG Yan-rong JIANG Ying LUO Wen-bo PENG Ding |
| |
| Affiliation: | PENG Yan-rong 1,JIANG Ying 1,LUO Wen-bo 2,PENG Ding 1 |
| |
| Abstract: | The changing rule of the deformed zone and non-deformed zone in the process of bending the vee parts is analyzed.A formula for calculation of the minimum depth of the bending female die is founded.Through an example,the influences of the part dimensions and the die radius on the minimum depth of the bending die are discussed. |
| |
| Keywords: | vee-bending female die depth deformed zone non-deformed zone |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
