| PC/PE共混体系在双螺杆挤出初期的形态演变EI |
| |
| 引用本文： | 尹波 赵印 安海宁 潘敏敏 杨鸣波. PC/PE共混体系在双螺杆挤出初期的形态演变EI[J]. 高分子材料科学与工程, 2006, 22(4): 192-195 |
| |
| 作者姓名： | 尹波 赵印 安海宁 潘敏敏 杨鸣波 |
| |
| 作者单位： | 四川大学高分子科学与工程学院高分子材料工程国家重点实验室 四川成都610065 |
| |
| 基金项目： | 教育部科学技术研究项目 |
| |
| 摘 要： | 研究了聚碳酸酯/聚乙烯(PC/PE)共混物在双螺杆挤出初期过程中的形态演变规律。用扫描电子显微镜(SEM)观察螺杆轴向不同位置的共混物分散相形态,分析了混合初期PC分散相形态的演变规律;建立了PC分散相在软化变形条件下,由颗粒状变化为片状、纤维状结构并最终破碎松弛为球形粒子的模型。讨论了混合初期螺杆构型对PC分散相形态的影响,发现增加捏合块数量能降低混合初期分散相的平均粒径及其分布。
|
| 关 键 词： | 聚碳酸酯/聚乙烯共混物 双螺杆挤出 形态演变 粒径 粒径分布 |
| 文章编号： | 1000-7555（2006）04-0192-04 |
| 收稿时间： | 2006-01-12 |
| 修稿时间： | 2006-03-02 |
Evolution of PC/PE Blend Morphology During the Initial Stages in a Twin-Screw Extruder |
| |
| YIN Bo, ZHAO Yin, AN Hai-ning, PAN Min-min, YANG Ming-bo. Evolution of PC/PE Blend Morphology During the Initial Stages in a Twin-Screw Extruder[J]. Polymer Materials Science & Engineering, 2006, 22(4): 192-195 |
| |
| Authors: | YIN Bo ZHAO Yin AN Hai-ning PAN Min-min YANG Ming-bo |
| |
| Affiliation: | College of Polymer Science and Engineering, State Key Laboratory of Polymer Materials Engineering, S ichuan University, Chen gdu 610065, China |
| |
| Abstract: | The evolution of the polycarbonate/polyethylene(PC/PE) blend morphology during the initial stages in a twin-screw extruder was studied using a scanning electron microscope(SEM).The effect of the screw configuration on the morphology of PC/PE blend during processing was discussed in detail.By comparing the effects of different screw configurations in the initial stages on the morphology evolution of PC/PE blend,it is found that the melting and breaking up of the dispersed phase are obviously influenced in the initial blending stages by the numbers of the kneading blocks.The average diameter and diameter distribution are reduced by the increase of the shear flow. |
| |
| Keywords: | PC/PE blend twin-screw extrusion morphology evolution average diameter diameter distribution |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
