| S7-300及工控组态软件WinCC的应用 |
| |
| 引用本文： | 李鸣. S7-300及工控组态软件WinCC的应用[J]. 兵工自动化, 2006, 25(7): 91-92 |
| |
| 作者姓名： | 李鸣 |
| |
| 作者单位： | 许昌烟草机械有限责任公司,河南,许昌,461000 |
| |
| 摘 要： | S7-300与WinCC间,经编程计算机设置通信端口、多点接口网络MPI地址、传输速率等参数,通过MPI端口对S7-300进行硬件组态,再将组态程序下载到PLC以确认,依次完成各PLC的组态后,便构建成MPI网络.组态后,在S7-300下设置标签,并用基本元件或图形库中对象制作生产工艺流程监控画面,将变量标签与每个对象连接,即可在CRT画面上监视、控制现场设备.
|
| 关 键 词： | 可编程控制器 多点接口网络 工控组态软件WinCC |
| 文章编号： | 1006-1576（2006）07-0091-02 |
| 收稿时间： | 2006-01-14 |
| 修稿时间： | 2006-04-06 |
Application of S7-300 and Labor Control Configuration Software WinCC |
| |
| LI Ming. Application of S7-300 and Labor Control Configuration Software WinCC[J]. Ordnance Industry Automation, 2006, 25(7): 91-92 |
| |
| Authors: | LI Ming |
| |
| Affiliation: | Xuchang Tobacco Machinery Co., Ltd., Xuchang 461000, China |
| |
| Abstract: | The programming computer sets up parameters such as the communication port, address of Multi-spots connection network MPI, the transfer rate, etc. carries on the hardware configuration to S7-300 through MPI port, downloads the configuration procedure to PLC again to confirm, after completing the configuration of each PLC in turn, the MPI network construction completes among S7-300 and WinCC. After the configuration, establishes the label under S7-300, and manufactures the monitoring picture of production technical process with the primary element or the object in graph storehouse; the variable label link with each object, then the system could monitor and control the scene equipments in the CRT picture. |
| |
| Keywords: | Programmable logic controller Multi-spots interface network Labor control configuration software WinCC |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
