R.F. sputtering system for the preparation of multilayer optical filters

Thin film multilayer optical filters are usually prepared by vacuum evaporation of successive layers. The deposition of thin films by sputtering has many advantages over the vacuum evaporation technique and hence it is employed for the fabrication of better quality optical filters. However, the filters may be more time consuming to prepare if a single-target sputtering system is used because two different materials are required for alternate layers. For the preparation of multilayer optical filters, a special r.f. sputtering jig arrangement with two target holders is fabricated. Using this the successive layers can be deposited in one pumpdown. A simple coupling arrangement used to match the r.f. generator output impedance to the load is explained. With all the sputtering parameters such as the pressure, the temperature and the power maintained constant except the time, control of the thickness of the multilayers is achieved. A calibration chart of sputtering time versus thickness of the materials to be deposited is prepared for TiO₂ and SiO₂ for the above purpose. Using this calibration chart, the deposition time of different layers of any optical filters based on these dielectric materials can be fixed to obtain optical filters of acceptable quality and reproducibility.