首页 | 本学科首页   官方微博 | 高级检索  
     

基于SAW的电缆接头内部测温天线研究
引用本文:张晓新,张兴磊,林峰,杨旭,马爽.基于SAW的电缆接头内部测温天线研究[J].压电与声光,2023,45(2):178-182.
作者姓名:张晓新  张兴磊  林峰  杨旭  马爽
作者单位:沈阳航空航天大学 电子信息工程学院,辽宁 沈阳 110163
基金项目:辽宁省自然科学基金资助项目(2022-BS-216)
摘    要:由于声表面波(SAW)测温技术因具有无源无线的特点而备受研究人员的广泛关注。该技术可应用在电缆接头内部的温度测量中,但因受电缆接头材料和结构的影响,使SAW测温信号传递受阻,严重影响了温度信号的检测。该文基于DWG-630A型电缆接头的结构和材料,设计了一款可用于电缆接头内部测温的天线。通过其理论分析、仿真及试验验证,证明该设计切实可行。结果表明,穿过电缆接头可传递SAW温度信号,并在工作频段内具有良好的增益和辐射效果。

关 键 词:电缆接头  声表面波温度传感器  天线  HFSS
收稿时间:2022/10/28 0:00:00

Research on Internal Temperature Measuring Antenna in Cable Joints Based on SAW
ZHANG Xiaoxin,ZHANG Xinglei,LIN Feng,YANG Xu,MA Shuang.Research on Internal Temperature Measuring Antenna in Cable Joints Based on SAW[J].Piezoelectrics & Acoustooptics,2023,45(2):178-182.
Authors:ZHANG Xiaoxin  ZHANG Xinglei  LIN Feng  YANG Xu  MA Shuang
Affiliation:College of Electronics and Information Engineering, Shenyang Aerospace University, Shenyang 110163 , China
Abstract:In recent years, surface acoustic wave (SAW) temperature measurement technology has received wide attention because of its passive and wireless characteristics. This technology can be applied to the temperature measurement in the cable joints. However, the SAW temperature measurement signal transmission is hindered by the influence of the material and structure of the cable joints, which seriously affects the temperature signal detection. Based on the structure and material of DWG-630A cable joints, this paper designs an antenna that can be used for temperature measurement in cable joints. Through the theoretical analysis, simulation and experimental verification, it is verifies the design is practical. The results show that it is feasible to transmit SAW temperature signal through the cable joints and has good gain and radiation effect in the operating frequency band.
Keywords:
点击此处可从《压电与声光》浏览原始摘要信息
点击此处可从《压电与声光》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号