| 填料填充UHMWPE交联塑料磨粒磨损性能研究 |
| |
| 引用本文： | 周晓谦,包学志.填料填充UHMWPE交联塑料磨粒磨损性能研究[J].塑料制造,2010(8):49-52. |
| |
| 作者姓名： | 周晓谦 包学志 |
| |
| 作者单位： | 辽宁工程技术大学材料科学与工程学院,辽宁阜新123000 |
| |
| 摘 要： | 本文采用二氧化硅、炭黑和还原铁粉三种填料对UHMWPE交联体系进行填充改性,采用模压烧结成型法制备了改性UHMWPE交联塑料,实验结果表明:三种填料对磨损率的影响比较一致,当二氧化硅含量6%、炭黑含量8%、还原铁粉含量2%时,磨粒磨损率最小。在磨粒磨损实验中,还原铁粉的含量对磨粒磨损率的影响最大。
|
| 关 键 词： | 超高分量聚乙烯 填充改性 磨损 拉伸强度 |
Reseach on Abrasive Wearing Properties of Croos-linking Modified UHMWPE |
| |
| ZHOU Xiao-qian,Bao Xue-zhi.Reseach on Abrasive Wearing Properties of Croos-linking Modified UHMWPE[J].Plastics Manufacture,2010(8):49-52. |
| |
| Authors: | ZHOU Xiao-qian Bao Xue-zhi |
| |
| Affiliation: | ZHOU Xiao-qian,Bao Xue-zhi(Material Science and Engineering Institute,Liaoning Technical University,Fuxin 123000) |
| |
| Abstract: | In this paper, cross-linking UHMWPE was modified by reduction iron power, carbon black and silicon dioxide, then modified plastics was gained by compression molding and sintering method. The experiment results showed that:the influence of three kind fillers is consistent to the rate of wear. When the silicon dioxide content is 6%, carbon black content is 8%, reducible Fe content is 2%, the abrasive rate of wear is smallest. In the abrasive attrition experiment, the influence of the content of reducible Fe i... |
| |
| Keywords: | UHMWPE Filling modification Wear Tensile strength |
| 本文献已被 CNKI 维普 等数据库收录！ |
|
