|
|||||
|
|
| 弹性隔套设计与仿真分析 | |
| 引用本文： | 余显忠,黄平辉,揭钢,陈学东,万雄飞. 弹性隔套设计与仿真分析[J]. 现代制造工程, 2010, 0(3) |
| 作者姓名： | 余显忠 黄平辉 揭钢 陈学东 万雄飞 |
| 作者单位： | 1. 华中科技大学数字制造装备与技术国家重点实验室,武汉,430074;江西江铃底盘股份有限公司,抚州,344000 2. 江西江铃底盘股份有限公司,抚州,344000 3. 华中科技大学数字制造装备与技术国家重点实验室,武汉,430074 |
| 基金项目： | 国家自然科学基金项目，国家973重点基础研究发展规划项目，江西省科技厅对外合作项目 |
| 摘 要： | 针对汽车驱动桥主齿轮中弹性隔套的设计问题,首先采用力学理论和弹塑性理论对其进行理论分析,然后采用有限元分析方法,在考虑加工成形和不考虑加工成形两种情况下,分别建立弹性隔套的有限元模型,利用有限元分析软件ABAQUS 6.8进行弹性隔套的弹塑性分析,并与试验进行对比分析。分析结论表明在考虑加工成形的工作条件下弹性隔套压力与应变的关系曲线与设计要求的关系曲线是一致的,进一步验证了设计与分析方法的有效性和正确性。 |
| 关 键 词： | 弹性隔套 有限元方法 弹塑性分析 仿真分析 |
Design and simulation analysis of the elastic sleeve |
|
| YU Xian-zhong,HUANG Ping-hui,JIE Gang,CHEN Xue-dong,WAN Xiong-fei. Design and simulation analysis of the elastic sleeve[J]. Modern Manufacturing Engineering, 2010, 0(3) | |
| Authors: | YU Xian-zhong HUANG Ping-hui JIE Gang CHEN Xue-dong WAN Xiong-fei |
| Affiliation: | YU Xian-zhong1,2,HUANG Ping-hui2,JIE Gang2,CHEN Xue-dong1,WAN Xiong-fei2(1 State Key Laboratory of Digital Manufacturing Equipment & Technology,Huazhong University of Science , Technology,Wuhan 430074,China,2 Jiangxi Jiangling Chassis Co.Ltd.,Fuzhou 344000,Jiangxi,China) |
| Abstract: | Basing on the design problem of elastic sleeve of active gear in the automobile drive axle,at first,the theory analysis is made by the mechanics and elastic-plastic theory.The finite element models are then set up with and without considering the process forming of the elastic sleeve,and the elastic-plastic analysis is carried out by using ABAQUS 6.8.By the comparison with the experiment results,it is sure that the relationship of the force and strain is reasonable in the work,which is further to prove the ... |
| Keywords: | elastic sleeve FEM elastic-plastic analysis simulation analysis |
| 本文献已被 CNKI 万方数据 等数据库收录！ | |