| 支架弯曲模设计 |
| |
| 引用本文： | 陈俊梅. 支架弯曲模设计[J]. 模具工业, 2013, 0(11): 34-36 |
| |
| 作者姓名： | 陈俊梅 |
| |
| 作者单位： | 成都凯天电子股份有限公司,四川成都610091 |
| |
| 摘 要： | 介绍支架成形的2种凸、凹模结构,对比2种结构的优缺点,得出在整体结构的基础上加以改进,形成镶拼的模具结构,生产的零件质量可靠,提高了生产效率。
|
| 关 键 词： | 多处折弯 镶拼 预压 回弹修正 弯曲模 |
Design of bending die for support part |
| |
| CHEN Jun-mei. Design of bending die for support part[J]. Die & Mould Industry, 2013, 0(11): 34-36 |
| |
| Authors: | CHEN Jun-mei |
| |
| Affiliation: | CHEN Jun-mei (AVIC Chengdu CAIC Electronics Co., Ltd., Chengdu, Sichuan 610091, China) |
| |
| Abstract: | Two punch and cavity die structure for a support part was presented and com- pared. Then the improvement was made based on inlaying structure with which the produc- tion rate was increased. |
| |
| Keywords: | multi-bending inlaying pre-stamping the springback correction bending die |
| 本文献已被 维普 等数据库收录！ |
|
