Hinge pivot for disk drive

This paper discusses the findings of a hinge pivot for use in hard disk drives (HDD). The actuator assembly in a HDD is supported by a pivot cartridge and controlled by a servo system to perform seek and track following operations for data recording. The cartridge is composed of a pair of pre-loaded ball bearings. Due to the demand for thin hard disk drives and hence, the need to reduce the height of the actuator assembly, a hinge pivot is proposed to replace the set of bearings. The shaft of the pivot is connected to the sleeve with thin hinges made of ultra-high heat-resistant polyamide film, such as Upilex. Measurement showed that the hinge pivot did not exhibit the nonlinear effects during low frequency actuation, such was inherent for ball bearing pivots. Experiment also showed that at least a million life cycles can be achieved without any performance degradation.