|
|||||
|
|
Microstructure and Tribological Properties of In-situ Synthesized TiB2- TiC/Ni Based Composite Coating by Laser Cladding |
|
| Authors: | SUN Rong-lu TANG Ying YANG Xian-jin |
| Affiliation: | 1. Laser Technology Institute of Tianjin Polytechnic University, Tianjin, China;Materials Science and Engineering School of Tianjin University, Tianjin, China 2. Laser Technology Institute of Tianjin Polytechnic University, Tianjin, China 3. Materials Science and Engineering School of Tianjin University, Tianjin, China |
| Abstract: | A TiB2 and TiC particles reinforced Ni based composites coating was prepared on TC4 alloy surface by chemical reaction among Ti, B and C elements using laser cladding technique. Microstructural analysis showed that the sizes of in-situ synthesized TiB2 and TiC particles ranged within 5~10um and l~2um, respectively, while both the two kinds of particles were uniformly distributed in the clad layer. The measurement of microhardness and wear and friction properties indicated that the microhardness of laser clad layer was HV900-1100, being three times of that of the TC4 alloy; the friction coefficient of the laser clad layer in air and in vacuum (10~5 Pa) ranged within 0.2-0.3 and 0.3-0.5, respectively; the wear rate in terms of mass loss was considerably lower than that of the TC4 alloy both in air and in vacuum environment. |
| Keywords: | Laser cladding In-situ synthesis Composite coating Microstructure Friction and wear property |
| 本文献已被 CNKI 万方数据 等数据库收录！ | |