| 塑料注射成型滞流现象分析及其解决方法 |
| |
| 引用本文： | 李健辉,黄志高,周华民,李德群,蔡考群. 塑料注射成型滞流现象分析及其解决方法[J]. 塑料工业, 2007, 35(6): 26-28 |
| |
| 作者姓名： | 李健辉 黄志高 周华民 李德群 蔡考群 |
| |
| 作者单位： | 华中科技大学材料成型与模具技术国家重点实验室,湖北,武汉,430074;深圳市群达行精密模具有限公司,广东,深圳,518129 |
| |
| 摘 要： | 通过塑料注射成型模拟软件HsCAE7.0对一产生滞流的制品进行分析,结果表明制品厚度不均或厚度突变是产生滞流的主要原因.依据此提出了解决滞流的几种方法,并通过一实例验证了其可行性.
|
| 关 键 词： | 滞流 注射成型 流动模拟 |
| 文章编号： | 1005-5770（2007）06-0026-03 |
| 修稿时间： | 2007-03-23 |
Analysis and Solution of Hesitation Phenomena in Plastic Injection Moulding |
| |
| LI Jian-hui,HUANG Zhi-gao,ZHOU Hua-min,LI De-qun,CAI Kao-qun. Analysis and Solution of Hesitation Phenomena in Plastic Injection Moulding[J]. China Plastics Industry, 2007, 35(6): 26-28 |
| |
| Authors: | LI Jian-hui HUANG Zhi-gao ZHOU Hua-min LI De-qun CAI Kao-qun |
| |
| Abstract: | The product which was effected by hesitation phenomena was analyzed by means of HsCAE 7.0 software. The results showed the non-homogeneity or mutation of the thickness of the product was the key reason for the hesitation phenomena, and based on which the solutions for the hesitation were recommended and the feasibility of the solutions was validated in the analysis of a part. |
| |
| Keywords: | Hesitation Plastic Injection Molding Filling Simulation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
