首页 | 本学科首页   官方微博 | 高级检索  
     

返红温度对钒钛微合金非调质钢45MnVTi组织性能的影响
引用本文:薛伟江,屈小波,王军,包耀宗.返红温度对钒钛微合金非调质钢45MnVTi组织性能的影响[J].特殊钢,2021,42(6):83-86.
作者姓名:薛伟江  屈小波  王军  包耀宗
作者单位:1江苏永钢集团有限公司,张家港 215628; 2钢铁研究总院,北京 100081
摘    要:试验研究了Φ52 mm 45MnVTi钢终轧917~922 ℃水冷返红680~830 ℃的组织和力学性能。结果表明,随着返红温度的降低,钢材的屈服强度及抗拉强度不同程度的升高,韧性先升高再降低,组织类型为铁素体和珠光体。当返红温度750~770 ℃时,钢材组织为均匀细小的铁素体和珠光体组织,且试验钢的珠光体片间距平均2.39 μm;钢材的抗拉强度平均841 MPa,屈服强度平均547.5 MPa,平均冲击功50.5 J,强韧性匹配最佳,满足使用要求。

收稿时间:2021-04-12

Effects of Self-Tempering Temperature on Microstructure and Performance of Vanadium and Titanium Microalloyed 45MnVTi Non Quenched and Tempered Steel
Xue Weijiang,Qu Xiaobo,Wang Jun,Bao Yaozong.Effects of Self-Tempering Temperature on Microstructure and Performance of Vanadium and Titanium Microalloyed 45MnVTi Non Quenched and Tempered Steel[J].Special Steel,2021,42(6):83-86.
Authors:Xue Weijiang  Qu Xiaobo  Wang Jun  Bao Yaozong
Affiliation:1 Jiang Su Yong Gang Group Co Ltd,Zhangjiagang 215628; 2 Central Iron and Steel Research Institute,Beijing100081
Abstract:The structure and mechenical properties of Φ52 mm 45MnVTi steel finished rolling at 917~922  ℃ and water-cooling-self-tempering with 680~830 ℃have been tested and researched.Results show that the microstructure of asprepared steel consists of ferrite and pearlite,with the decrease of self-tempering temperature,the yield strength and tensile strength of steel gradually increase,and toughness increases at first and then decreases. When the range of self-tempering temperature is 750 to 770 ℃,the microstructure of steel products is fine ferrite and pealite, and the test steel average value of tensile Strength 841 MPa,yield Strength 547.5 MPa,impact energy 50.5 J with an optimal match between the strength and toughness of steel and pearite lamellar spacing 2.39 μm,to meet the use requirements.
Keywords:
点击此处可从《特殊钢》浏览原始摘要信息
点击此处可从《特殊钢》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号