| 角撑件多工位级进模设计 |
| |
| 引用本文： | 刘占军,王铁丽,吴钢,师建民. 角撑件多工位级进模设计[J]. 模具工业, 2007, 33(4): 32-34 |
| |
| 作者姓名： | 刘占军 王铁丽 吴钢 师建民 |
| |
| 作者单位： | 沈阳航空工业学院,辽宁,沈阳,110034;天马医药工程安装有限公司,辽宁,沈阳,110034 |
| |
| 摘 要： | 分析了角撑件的工艺性,介绍了其特殊级进模的总体设计结构和排样方案。实践证明:该模具结构合理、可靠,并能保证产品质量,对此类零件的级进模设计有重要参考价值。
|
| 关 键 词： | 角撑件 级进模 排样设计 |
| 文章编号： | 1001-2168(2007)04-0032-03 |
| 修稿时间： | 2006-09-01 |
A multi-position progressive die for angle bracket |
| |
| LIU Zhan-jun,WANG Tie-li,WU-Gang,SHI Jian-min. A multi-position progressive die for angle bracket[J]. Die & Mould Industry, 2007, 33(4): 32-34 |
| |
| Authors: | LIU Zhan-jun WANG Tie-li WU-Gang SHI Jian-min |
| |
| Affiliation: | 1. Shenyang Institute of Aeronautical Engineering, Shenyang, Liaoning 110034, China; 2. Tianma Medicine Engineering Fixing Co., Ltd, Shenyang, Liaoning 110034, China |
| |
| Abstract: | The manufacturability of an angle bracket was analyzed.The structural design of a progressive die for forming the piece and the layout design were presented.The application shows that the die operates smoothly and reliably. |
| |
| Keywords: | angle bracket progressive die layout design |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
