Fabrication and structural tuning of novel composite hollow fiber membranes for pervaporation

A series of polysiloxaneimide (PSI)/polyetherimide (PEI) composite hollow fibers were fabricated by coextrusion and phase inversion. The hydrophobic PSI outer layer was set as the selective layer which was supported by the PEI inner layer. The PSI was synthesized by polycondensation of 3,3′,4,4′‐Biphenyltetracarboxylic Dianhydride (BPDA) with amino siloxane X‐22‐161A and a chain extender, 1,3‐Bis (3‐aminopropyl) ?1,1,3,3‐tertramethyldisiloxane (BATS). It was found that the macroscopic uniformity of PSI layer was dependent on the dope formulation, coagulant composition and dope flow rate: (1) the higher similarity degree of the solvent(s) for different layers in terms of solubility parameters, (2) the utilization of surfactant as a component in the water coagulant, and (3) higher flow rates of the outer layer dopes, led to the formation of more uniform and smoother PSI outer layer. The maximum outer layer thickness was around 2 μm. The bulk of the PEI layers were porous with finger like macrovoids. The outer surface of the inner PEI layer for some batches of the hollow fibers was confirmed to be porous. The original dual‐layer hollow fibers showed poor pervaporation performance. Post treatment was applied to cure the hollow fiber, delivering composite membranes with performance dominated by the coating material of PDMS. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016 , 133, 43324.