| 粉末成形设备PLC控制系统的设计 |
| |
| 引用本文： | 叶宏克,邱诚,邵明. 粉末成形设备PLC控制系统的设计[J]. 现代制造工程, 2006, 0(12): 95-97 |
| |
| 作者姓名： | 叶宏克 邱诚 邵明 |
| |
| 作者单位： | 华南理工大学机械工程学院,广州,510640 |
| |
| 基金项目： | 广东省关键领域重点突破粤港招标项目 |
| |
| 摘 要： | 介绍2000kN数控精密金属粉末成形设备PLC控制系统的设计过程。根据系统要求,分别对控制系统的硬件和软件两个方面进行选择和设计,选用西门子公司的SIMATIC S7-300可编程控制器。为能够生产上二下三台面的粉末成形零件,控制系统需要分别对阴模、上内模冲、上外模冲、下内模冲、下中模冲、下外模冲进行控制,用户可以根据需要调整各模冲的位置、速度和压力,提高成形零件的精度和质量。
|
| 关 键 词： | 粉末成形 设备 控制系统 可编程控制器 |
| 文章编号： | 1671-3133(2006)12-0095-03 |
| 修稿时间： | 2006-08-03 |
Design of PLC control system for powder-forming equipment |
| |
| Ye Hongke,Qiu Cheng,Shao Ming. Design of PLC control system for powder-forming equipment[J]. Modern Manufacturing Engineering, 2006, 0(12): 95-97 |
| |
| Authors: | Ye Hongke Qiu Cheng Shao Ming |
| |
| Abstract: | Introduces the design of PLC control system for a 200 tons powder-forming equipment.According to system demands,it is chosen and designed for hardware and software of the control system,and SIMATIC S7-300 programmable controller of SIEMENS Corporation is chosen.For producing powde-forming parts with two upper boards and three lower boards,it is needed for the control system to control respectively female die,upper-and-inside plunger,upper-and-outside plunger,lower-and-inside plunger,lower-and-middle plunger,lower-and-outside plunger.If it's needed,users can adjust position,speed and pressure of plungers to promote precision and quality of parts. |
| |
| Keywords: | Powder forming Equipment Control system PLC |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
