| 基于UG和ADAMS的6R切削机器人运动仿真 |
| |
| 引用本文： | 王金师,王友林,于苗苗,刘坤,洪晓燕.基于UG和ADAMS的6R切削机器人运动仿真[J].机械工程师,2012(5):55-56. |
| |
| 作者姓名： | 王金师 王友林 于苗苗 刘坤 洪晓燕 |
| |
| 作者单位： | 1. 山东理工大学机械工程学院,山东淄博,255091
2. 德州科技职业学院,山东德州,251200 |
| |
| 摘 要： | 利用UG强大的建模功能,建立了6R切削机器人的三维实体模型,以Parasolid格式输出,然后利用ADAMS与UG软件良好的接口功能,将上述三维实体模型导入ADAMS软件中进行运动学仿真,得到了6R切削机器人的运动轨迹,为以后的动力学分析和运动控制奠定了基础。
|
| 关 键 词： | 运动学 UG ADAMS 仿真 |
Kinematics Simulation of 6R Cutting Robot Based on UG and ADAMS |
| |
| WANG Jin-shi
,
WANG You-lin
,
YU Miao-miao
,
LIU Kun
,
HONG Xiao-yan.Kinematics Simulation of 6R Cutting Robot Based on UG and ADAMS[J].Mechanical Engineer,2012(5):55-56. |
| |
| Authors: | WANG Jin-shi WANG You-lin YU Miao-miao LIU Kun HONG Xiao-yan |
| |
| Affiliation: | 1.School of Machinery Engineering,Shandong University of Technology,Zibo 255091,China; 2.Dezhou Vocational College of Science and Technology,Dezhou 251200,China) |
| |
| Abstract: | A three-dimensional solid model of 6R cutting robot is established by using UG powerful modeling function and by using good interface function between ADAMS and UG,the solid model is exported to ADAMS in this format of Parasolid in order to do kinematical simulation and then,trajectory of the 6R cutting robot is obtained,which laid the foundation for later dynamics analysis and kinematics control of the foundation. |
| |
| Keywords: | kinematics UG ADAMS simulation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
