首页 | 本学科首页   官方微博 | 高级检索  
     

纤维缠绕CFRP圆管力学性能的试验研究
引用本文:张亮泉,李惠.纤维缠绕CFRP圆管力学性能的试验研究[J].工业建筑,2009,39(8).
作者姓名:张亮泉  李惠
作者单位:1. 东北林业大学土木工程学院,哈尔滨,150040;哈尔滨工业大学土木工程学院,哈尔滨,150090
2. 哈尔滨工业大学土木工程学院,哈尔滨,150090
基金项目:国家杰出青年基金项目资助(50525823);;国家自然科学基金重点项目资助(50538020)
摘    要:采用纤维缠绕成型工艺,设计两种尺寸的CFRP圆管,铺层方式均为(90°/0°)2]S,对CFRP圆管进行压缩和拉伸试验,着重研究CFRP圆管在这两种受力状态下直至破坏的应力-应变关系,极限强度以及材料宏观破坏模式。试验结果表明:铺层方式为(90°/0°)2]S的CFRP圆管抗拉极限强度和应变远大于其抗压极限强度和应变,但这两种状态下CFRP圆管的弹性模量大致相当,且破坏模式均为脆性破坏。

关 键 词:碳纤维增强复合材料  极限强度  破坏模式

EXPERIMENTAL STUDY ON MECHANICAL PROPERTIES OF FILAMENT-WOUND CFRP TUBES
Zhang Liangquan,Li Hui.EXPERIMENTAL STUDY ON MECHANICAL PROPERTIES OF FILAMENT-WOUND CFRP TUBES[J].Industrial Construction,2009,39(8).
Authors:Zhang Liangquan  Li Hui
Affiliation:1;2;1.School of Civil Engineering;Northeast Forestry University;Harbin 150040;China;2.School of Civil Engineering;Harbin Institute of Technology;Harbin 150090;China
Abstract:The paper presents the results of an experimental and numerical investigation into the behaviour of carbon-fiber-reinforced epoxy tubes subjected to monotonic uniaxial loading.These tubes were winded by carbon fibers with a filament winding pattern of (90°/0°)_2]_S.Two sizes of tubes were tested in a testing machine to investigate basic properties under uniaxial compression and tension loading.The resulting stress and strain curves were analyzed and the damage and failure modes were observed.It is shown that the ultimate stress and strain under tension are much larger than those under compression,however,the elastic module under these two states are similar if the CFRP tubes are winded with a filament winding pattern of 90°/0°.
Keywords:carbon fiber reinforced plastic  ultimate intensity  destroy mode  
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号