| 法兰轴温挤压成形工艺分析与挤压凸、凹模参数优化 |
| |
| 引用本文： | 柴蓉霞,于力,郭成.法兰轴温挤压成形工艺分析与挤压凸、凹模参数优化[J].模具工业,2012,38(9):62-66. |
| |
| 作者姓名： | 柴蓉霞 于力 郭成 |
| |
| 作者单位： | 1. 西安交通大学 机械工程学院,陕西西安,710049
2. 中国兵器北方通用电子集团有限公司,陕西西安,710100 |
| |
| 摘 要： | 在分析法兰轴温挤压工艺的基础上,制定了法兰轴的温挤压工艺流程,采用正交试验法对挤压凸、凹模结构参数进行了优化,将优化的凸、凹模结构参数对法兰轴进行温挤压成形试制与验证,得到了合格零件,证明了法兰轴成形工艺方案的正确性。
|
| 关 键 词： | 法兰轴 温挤压 模具 数值模拟 正交试验 参数优化 |
Analysis of warm extrusion process for flange shaft and parameter optimization of punch and die |
| |
| CHAI Rong-xia
,
YU Li
,
GUO Cheng.Analysis of warm extrusion process for flange shaft and parameter optimization of punch and die[J].Die & Mould Industry,2012,38(9):62-66. |
| |
| Authors: | CHAI Rong-xia YU Li GUO Cheng |
| |
| Affiliation: | 1.School of Mechanical Engineering, Xi＇an Jiaotong University, Xi＇an, Shaanxi 710049, China; 2.Norinco North General Electronic Group Co., Ltd., Xi＇an, Shaanxi 710100, China) |
| |
| Abstract: | On the basis of analyzing the warm extrusion process of a flange shaft, a pro- cess scheme for warm extruding the flange shaft was determined and the parameters of punch and die structure were optimized through orthogonal test. The optimized parameters and warm extrusion process are validated by trial production. |
| |
| Keywords: | flange shaft warm extrusion die numerical simulation orthogonal test parame- ter optimization |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
