Influence of ZnO nanoparticles on the cure characteristics and mechanical properties of carboxylated nitrile rubber

Zinc oxide (ZnO) nanoparticles assembled in one dimension to give rod‐shaped morphology were synthesized. The effect of these ZnO nanoparticles (average particle size ～ 50 nm) as the curing agent for carboxylated nitrile rubber was studied with special attention to cure characteristics, mechanical properties, dynamic mechanical properties, and swelling. These results were compared with those of the conventional rubber grade ZnO. The study confirmed that the ZnO nanoparticles gave a better state of cure and higher maximum torque with a marginal decrease in optimum cure time and scorch time. The mechanical properties also showed an improvement. There was an increase in tensile strength by ～ 120%, elongation at break by ～ 20%, and modulus at 300% elongation by ～ 30% for the vulcanizate cured with ZnO nanoparticles, as compared with the one containing rubber grade ZnO. Dynamic mechanical analysis revealed that the vulcanizates exhibited two transitions—one occurring at lower temperature due to the T_g of the polymer, while the second at higher temperature corresponding to the hard phase arising due to the ionic structures. The second transition showed a peak broadening because of an increase in the points of interaction of ZnO nanoparticles with the matrix. The tan δ peak showed a shift towards higher T_g in the case of ZnO nanoparticle‐cured vulcanizate, indicating higher crosslinking density. This was further confirmed by volume fraction of rubber in the swollen gel and infrared spectroscopic studies. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2007