| 基于三维实体模型的多坐标数控加工过程仿真 |
| |
| 引用本文： | 高利辉,王润孝,殷磊,张研. 基于三维实体模型的多坐标数控加工过程仿真[J]. 机械设计与制造, 2002, 0(3): 87-89 |
| |
| 作者姓名： | 高利辉 王润孝 殷磊 张研 |
| |
| 作者单位： | 张研,西北工业大学,西安,710072 |
| |
| 摘 要： | 概述了目前数控加工程序仿真系统的各种设计方法,分析了在三维实体模型中多坐标数控加工过程仿真研究的关键技术,并提出了实现方法。通过实际仿真系统的开发和系统运行表明,提出的方法简洁有效,系统运行可靠。
|
| 关 键 词： | 数控加工 数控程序 图形仿真 三维实体模型 |
| 文章编号： | 1001-3997(2002)03-0087-02 |
| 修稿时间： | 2001-08-09 |
The simulation based on 3D solid model of multi -axes NC milling process |
| |
| GAO Li-hui,WANG Run-xiao,YIN Lei,ZHANG Yan. The simulation based on 3D solid model of multi -axes NC milling process[J]. Machinery Design & Manufacture, 2002, 0(3): 87-89 |
| |
| Authors: | GAO Li-hui WANG Run-xiao YIN Lei ZHANG Yan |
| |
| Abstract: | This paper summarizes all kinds of designing methods of simulation systems of NC milling process,and analyzes the key techniques in research and development of Simulation based on 3D solid model of multi-axes NC milling process,at the same time,gives feasible and effective methods.The factual development and running of NC simulation system shows the proposed methods is concise and practicable.The NC simulation system can runs smoothy and reliably. |
| |
| Keywords: | NC milling NC codes Graphic simulation 3D solid model |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
