| 金属陶瓷刀具切削性能的研究 |
| |
| 引用本文： | 陈焱,刘宁.金属陶瓷刀具切削性能的研究[J].硬质合金,2007,24(4):226-231. |
| |
| 作者姓名： | 陈焱 刘宁 |
| |
| 作者单位： | 合肥工业大学材料科学与工程学院,合肥,230009 |
| |
| 摘 要： | 本文研究了纳米TiN改性的TiC基金属陶瓷刀具和超细晶Ti(C,N)基金属陶瓷刀具切削正火态45#钢的切削性能,尝试用SPSS11.5软件对正交试验的数据进行分析。结果表明,这两种刀具的最佳切削条件均为vc=200m/min,ap=0.3mm,f=0.1mm/r。最后分析了它们切削45#钢的磨损机理。
|
| 关 键 词： | 金属陶瓷刀具 正交试验法 方差分析 SPSS11.5 磨损机理 |
| 收稿时间： | 2007-05-30 |
| 修稿时间： | 2007-09-17 |
Research on Cutting Properties of Cermet Cutters |
| |
| Chen Yan,Liu Ning.Research on Cutting Properties of Cermet Cutters[J].Cemented Carbide,2007,24(4):226-231. |
| |
| Authors: | Chen Yan Liu Ning |
| |
| Abstract: | The cutting properties of two kinds of cermets cutters were studied for cutting 45# steel,one was nano TiN modified TiC-based cermets cutter and another was ultra-fine Ti(C,N)-based cermets cutter. The dates of orthogonal experiment were analyzed in SPSS11.5. The results showed that the optimal parameter of both cutters was vc=200m/min,ap=0.3mm,f=0.1mm/r. At the end of this paper the wear mechanism of two cutters was discussed. |
| |
| Keywords: | SPSS11 5 |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
