| 双组分聚合物LDPE/PS共挤出过程的三维有限元分析 |
| |
| 引用本文： | 张敏,孙胜,贾玉玺.双组分聚合物LDPE/PS共挤出过程的三维有限元分析[J].中国机械工程,2006,17(8):862-865,869. |
| |
| 作者姓名： | 张敏 孙胜 贾玉玺 |
| |
| 作者单位： | 1. 山东大学,济南,250061
2. 山东大学,济南,250061;中国科学院长春应用化学研究所高分子物理与化学国家重点实验室,长春,130022 |
| |
| 基金项目： | 中国科学院资助项目;国家重点基础研究发展计划(973计划) |
| |
| 摘 要： | 采用有限元方法对两种聚合物熔体（LDPE／PS）在共挤出流道内的流动进行了三维数值模拟，分析了两种熔体的入口体积流量比、熔体与模具壁面之间的滑移系数等物理量对于共挤出界面位置和形状的影响。结果表明：随着流量差异的增加，界面位置偏移量增大，同时出口截面上熔体界面曲线的曲率增大；提高流道表面质量可以使熔体速度场趋于均匀，并显著减小界面位置的偏移量。
|
| 关 键 词： | 共挤出 数值模拟 非牛顿流体 壁面滑移 |
| 文章编号： | 1004-132X（2006）08-0862-04 |
| 收稿时间： | 2005-08-05 |
| 修稿时间： | 2005-08-05 |
Three-dimensional Finite Element Analysis of LDPE/PS Coextrusion Processes |
| |
| Zhang Min,Sun Sheng,Jia Yuxi.Three-dimensional Finite Element Analysis of LDPE/PS Coextrusion Processes[J].China Mechanical Engineering,2006,17(8):862-865,869. |
| |
| Authors: | Zhang Min Sun Sheng Jia Yuxi |
| |
| Affiliation: | 1. Shandong University, Jinan, 250061 ;2. State Key Laboratory of Polymer Physics and Chemistry, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences, Changehun, 130022 |
| |
| Abstract: | The three-dimensional flow of non-Newtonian polymer melts (LPDE/PS) in coextrusion dies was analyzed based on finite element simulations.Such simulated results as the interfacial offset and shape and the velocity profile were obtained.It is found that the fluid flux ratio of LDPE to PS notably affects the shape and location of the interface between them,and that the interfacial offset increases with the increase of the fluid flux difference.The simulated results were compared with Gifford's results,and then were confirmed.The simulated results also show that the higher surface quality of the fluid path can make the velocity field more uniform and the interfacial offset less. |
| |
| Keywords: | coextrusion numerical simulation non--Newtonian fluid wall slip |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
