The Effect of Cutting Parameters on Workpiece Surface Roughness in Wire EDM |
| |
Authors: | N Tosun C Cogun A Inan |
| |
Affiliation: |
a Mechanical Engineering Department, Firat University, Elazig, Turkey
b Mechanical Engineering Department, Gazi University, Ankara, Turkey |
| |
Abstract: | In this study, the variation of workpiece surface roughness with varying pulse duration, open circuit voltage, wire speed and dielectric fluid pressure was experimentally investigated in Wire Electrical Discharge Machining (WEDM). Brass wire with 0.25 mm diameter and SAE 4140 steel with 10 mm thickness were used as tool and workpiece materials in the experiments, respectively. It is found experimentally that the increasing pulse duration, open circuit voltage and wire speed, increase the surface roughness whereas the increasing dielectric fluid pressure decreases the surface roughness. The variation of workpiece surface roughness with machining parameters is modelled by using a power function. The level of importance of the machining parameters on the workpiece surface roughness is determined by using analysis of variance (ANOVA). |
| |
Keywords: | Wire EDM Surface roughness ANOVA |
本文献已被 InformaWorld 等数据库收录! |
|