| 背压对AZ31镁合金板材快速气压胀形的影响 |
| |
| 引用本文： | 崔令江,王刚,刘承勃.背压对AZ31镁合金板材快速气压胀形的影响[J].塑性工程学报,2012,19(6). |
| |
| 作者姓名： | 崔令江 王刚 刘承勃 |
| |
| 作者单位： | 哈尔滨工业大学(威海)材料学院,威海,264209 |
| |
| 基金项目： | 哈尔滨工业大学科研创新基金资助项目 |
| |
| 摘 要： | 利用快速气压胀形实验,研究背压对AZ31镁合金轧制板材胀形时空洞体积分数、胀形高度和壁厚分布的影响。研究结果表明,在胀形温度为350℃的工艺条件下,胀形件顶部在无背压和加载背压时,空洞的比率分别达到了21%和16%。在相同的应变下,加载背压时获得的胀形件中的空洞比率小于无背压时的空洞比率。背压的加载,能有效降低板材中空洞的分布比率,提高板材的胀形高度,进而提高成形极限。
|
| 关 键 词： | 背压 快速气压胀形 空洞 成形极限 |
Effect of back pressure on quick gas blow forming for AZ31 magnesium alloy sheet |
| |
| CUI Ling-jiang
,
WANG Gang
,
LIU Cheng-bo.Effect of back pressure on quick gas blow forming for AZ31 magnesium alloy sheet[J].Journal of Plasticity Engineering,2012,19(6). |
| |
| Authors: | CUI Ling-jiang WANG Gang LIU Cheng-bo |
| |
| Abstract: | The effects of back pressure on volume fraction of cavity,bulging height and wall thickness distribution during free bulging were studied through quick gas blow forming tests of AZ31 magnesium alloy rolled sheet.Experimental results showed that under the forming temperature of 350℃,the volume fraction of cavity was 21% and 16% respectively at the dome with back pressure and no back pressure.If the strain was same,the volume fraction of as-formed part with back pressure was smaller than that with no back pressure.Loading of back pressure could reduce effectively the volume fraction of sheet material,and increase the bulging height and thus forming limit. |
| |
| Keywords: | back pressure quick gas blow forming cavity forming limit |
| 本文献已被 万方数据 等数据库收录！ |
|
