卷取温度对深冲DP钢组织性能及织构的影响 |
| |
引用本文: | 叶洁云,安桂焕,刘姗姗,刘蔚宁,汪志刚.卷取温度对深冲DP钢组织性能及织构的影响[J].钢铁,2016(12):74-79. |
| |
作者姓名: | 叶洁云 安桂焕 刘姗姗 刘蔚宁 汪志刚 |
| |
作者单位: | 1. 江西理工大学材料科学与工程学院,江西 赣州,341000;2. 国家电网公司交流建设分公司,北京,100031 |
| |
基金项目: | 江西省重点计划资助项目(2016BBE50065) |
| |
摘 要: | 为研究深冲织构的演变规律,利用OM、TEM和XRD等技术研究了热轧卷取温度对微碳深冲DP钢组织、性能与织构的影响。结果表明,热轧板主要由铁素体+珠光体构成,随卷取温度升高,铁素体晶粒略增大,伸长率逐渐上升;热轧板中钼基碳化物的最佳析出温度为700℃;与650和750℃相比,700℃卷取后的退火板能获得较高体积分数(4.0%)马氏体与较细(11.7μm)铁素体的组织特征,同时拥有最强的〈111〉//ND纤维织构和最弱的{001}〈110〉织构,使得其抗拉强度达到455 MPa,塑性应变比r值达1.5。
|
关 键 词: | 双相钢 卷取温度 织构 组织 性能 |
Effect of hot-rolled coiling temperature on microstructure,properties and textures of micro-carbon deep-drawing DP steel |
| |
Abstract: | In order to study the charge rule of texture on deep-drawing DP steel,effect of hot-rolled coiling temperature on microstructure,properties and textures of micro-carbon deep drawing DP steel were studied by OM,TEM and XRD technical. The research shows that:microstructure of hot-rolled plates is mainly composed of ferrite and pearlite. With the increasing of coiling temperature,the grain size of ferrite increased slightly,and elongation of hot-rolled plate en-hanced gradually. The optimum precipitation temperature of Mo-based carbide in hot-rolled plate is 700℃. A higher vol-ume fraction (4%) of martensite and finer (11.7μm) ferrite observed in annealed sheet on 700℃coiling compared with 650 and 750 ℃. Meanwhile,the strongest〈111〉//ND fiber texture and weakest {001}〈110〉texture achieved in an-nealed sheet. The tensile strength and r value of annealed sheet on 700℃ coiling reach to 455 MPa and1.5,respectively. |
| |
Keywords: | dual-phase steel coiling temperature texture microstructure mechanical properties |
本文献已被 万方数据 等数据库收录! |
|