Experimental investigation and flow visualisation of the resin transfer mould filling process for non-woven hemp reinforced phenolic composites

Resin transfer moulding (RTM) of glass fibre reinforced polymeric composites offers the advantages of automation, low cost and versatile design of fibre reinforcement. A replacement of glass fibres with natural plant fibres as reinforcement in polymeric composites provides additional technological, economical, ecological and environmental benefits. The resin transfer mould filling process has significant effects on different aspects, such as fibre wetting out and impregnation, injection gate design, “dry patch” and void formation. Flow visualisation experiments were carried out using a transparent RTM mould to develop a better understanding of the mould filling process for hemp mat reinforced phenolic composites. The mould filling of unreinforced phenolics was characterised by a “quasi-one-dimensional steady state” flow. In the case of hemp non-woven reinforced system, the mould filling process can be considered as the flow of fluids through porous media. “Fibre washing” was a typical problem encountered during the injection process, leading to poor property uniformity. In addition, a preferential flow path was usually created near the edges and corners of the mould. The path exhibited low flow resistance and caused the resin flow front to advance much faster in these regions. The edge flow disturbed the steady flow, leading to difficulties in venting arrangement and “dry patch” formation. The edge flow and fibre washing were alleviated by reinforcement manipulation so steady state flow could be achieved. The relationships between the filling time and injection pressure and between filling time and different fibre weight fractions have been established for certain specific injection strategies.