| 翼子板裙板成形工艺分析及有限元模拟 |
| |
| 引用本文： | 杨博,刘建生. 翼子板裙板成形工艺分析及有限元模拟[J]. 锻压装备与制造技术, 2006, 41(2): 52-54 |
| |
| 作者姓名： | 杨博 刘建生 |
| |
| 作者单位： | 太原科技大学,材料科学与工程学院,山西,太原,030024;太原科技大学,材料科学与工程学院,山西,太原,030024 |
| |
| 摘 要： | 分析了翼子板裙板的工艺特点，并制定了合理的工艺方案，重点介绍了一模四件的拉延模的设计与制造，同时采用板料三维成形分析软件Dynaform对其拉深成形工序进行了数值模拟仿真，得到了合理的拉深工艺补充型面及拉深工艺参数。这种一模四件的模具结构，极大地提高了材料的利用率，同时提高了劳动生产率，节约了生产成本，并且有利于材料的流动。
|
| 关 键 词： | 机械制造 拉深 翼子板裙板 数值模拟 |
| 文章编号： | 1672-0121(2006)02-0052-03 |
| 修稿时间： | 2006-01-12 |
Analysis of the Forming Process for the Fender Groupware and FEM Simulation |
| |
| YANG Bo,LIU Jiansheng. Analysis of the Forming Process for the Fender Groupware and FEM Simulation[J]. China Metalforming Equipment & Manufacturing Technology, 2006, 41(2): 52-54 |
| |
| Authors: | YANG Bo LIU Jiansheng |
| |
| Abstract: | The technological characteristics of the fender groupware have been analyzed and a reasonable technological process has been worked out with emphasis on introduction to the design and manufacture of the drawing die capable of forming four parts at one time. The reasonable process addendum and the process parameters have been obtained by using the 3D sheet metal forming analysis software Dynaform. The utilization ratio of material has been increased and the productivity improved by use of such structure, with a reduced cost and helpful to the flowing of material. |
| |
| Keywords: | Machinery manufacture Drawing Fender groupware Numerical simulation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
