Abstract: | Moldability and mechanical properties of polyethylene terephthalate (PET) under normal molding conditions were found to improve significantly when it was blended with bisphenol-A-polycarbonate (PC) and polypropylene (PP) to form ternary polymer blend systems. DSC results of these blends revealed that the PET and PC components formed a miscible blend while PP being incompatible with them, formed a separate phase. PP was also found to form a sleeve around the PET-PC miscible phase and, thereby, showed a skin-core type of morphology. Variations of mechanical properties with varying amounts of PP was measured keeping the ratio of PET and PC constant. Tensile and flexural properties of the blends decrease with the amount of PP. Notched impact strength increases up to a certain level of PP and then decreases, while the unnotched values decrease gradually. The effect of annealing on the mechanical properties of these blends have been discussed on the basis of the increased crystallinity of some of the components. |