| 线材测径仪小车故障分析及改进 |
| |
| 引用本文： | 金萍,杨冰,高德柱,刘磊刚,梁琪. 线材测径仪小车故障分析及改进[J]. 鞍钢技术, 2014, 0(2): 59-62 |
| |
| 作者姓名： | 金萍 杨冰 高德柱 刘磊刚 梁琪 |
| |
| 作者单位： | 鞍钢股份有限公司线材厂 辽宁 鞍山 114042;鞍钢集团公司物资采购招标中心 辽宁 鞍山 114032 |
| |
| 摘 要： | 对线材测径仪小车发生堆钢故障进行了分析,找出了小车强度和刚度不足、定位精度不高和测径仪自身动平衡不良是造成故障频发的主要原因,提出了将小车由一体式改进为2台小车、改进小车定位机构、增设小车锁紧机构等措施。措施实施后,解决了双模块轧机后测径仪入、出口导管处频繁堆钢问题。
|
| 关 键 词： | 线材 双模块轧机 测径仪 定位机构 锁紧机构 |
Fault Analysis and Improvement of Caliper Gauge Car for Wire Rod |
| |
| Jin Ping,Yang Bing,Gao Dezhu,Liu Leigang,Liang Qi. Fault Analysis and Improvement of Caliper Gauge Car for Wire Rod[J]. Aisc Techniques, 2014, 0(2): 59-62 |
| |
| Authors: | Jin Ping Yang Bing Gao Dezhu Liu Leigang Liang Qi |
| |
| Affiliation: | 1. Wire Rod Rolled Mill of Angang Steel Co., Ltd., Anshan 114042, Liaoning, China; 2. Materials Procurement Public Bidding Center of Angang Steel Group Corporation, Anshan 114032, Liaoning, China) |
| |
| Abstract: | The fault of steel stoppage occurred during measurement by the caliper gauge car for wire rods is analyzed. It is found that frequent faults are mainly caused by low strength and stiffness of the car, low accuracy of positioning and bad dynamic balancing of the caliper gauge. So such countermeasures as upgrading the car by changing the integrated car into two-piece car, improving its positioning mechanism and installing the locking mechanism to the car are proposed. After these measures are taken, the problem of frequent steel stoppage faults occurred at the inlet and outlet for the caliper gauge located behind twin module block （TMB） finishing mill is solved. |
| |
| Keywords: | wire rod TMB finishing mill caliper gauge positioning mechanism loc kingmechanism |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
