| 门体手把加强板成形工艺分析及模具设计 |
| |
| 引用本文： | 丁鹏,李卫强.门体手把加强板成形工艺分析及模具设计[J].模具工业,2004(1):29-31. |
| |
| 作者姓名： | 丁鹏 李卫强 |
| |
| 作者单位： | 河南新飞电器有限公司,河南新乡,453002 |
| |
| 摘 要： | 分析了竖手把加强板冲压件的结构及成形工艺,介绍了各冲压工序的模具结构及工作过程,提出了模具设计及制造时应注意的事项。
|
| 关 键 词： | 加强板 工艺分析 弯曲成形 |
| 文章编号： | 1001-2168(2004)01-0029-03 |
| 修稿时间： | 2003年7月10日 |
Analysis of the Forming Technology for the Reinforcing Plate of the Door Handle and Design of the Die |
| |
| DING Peng,LI Wei-qiang.Analysis of the Forming Technology for the Reinforcing Plate of the Door Handle and Design of the Die[J].Die & Mould Industry,2004(1):29-31. |
| |
| Authors: | DING Peng LI Wei-qiang |
| |
| Abstract: | The structure and the technological process of the reinforcing plate part of the vertical door handle are analyzed.The structure and working process of the die on each operation are introduced.And the points for attention in the design and manufacture of the dies are listed. |
| |
| Keywords: | reinforcing plate technological analysis bending |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
