| 磷脱氧铜管焊接漏气失效分析 |
| |
| 引用本文： | 贾延琳,汪明朴,李周. 磷脱氧铜管焊接漏气失效分析[J]. 理化检验(物理分册), 2006, 42(2): 92-94 |
| |
| 作者姓名： | 贾延琳 汪明朴 李周 |
| |
| 作者单位： | 中南大学材料科学与工程学院,长沙,410083;中南大学材料科学与工程学院,长沙,410083;中南大学材料科学与工程学院,长沙,410083 |
| |
| 摘 要： | 针对磷脱氧铜管与低碳钢储罐钎焊后漏气失效问题，采用金相、扫描电镜（SEM）和能谱分析（EDAX）对失效器件进行分析，发现铜管漏气的主要原因是由于钎焊过程中，预热和钎焊工艺不恰当，导致焊接气氛交替出现氧化性和还原性，使得铜管发生氢脆，产生裂纹。同时在加热和冷却时，由于异种材料的热胀系数差别过大，产生的较大热应力作用于已存在的裂纹，促使裂纹二次扩展，甚至使得晶粒脱落产生空洞，最终导致焊接接头漏气失效。提出了合理控制燃气比、钎焊加热时间和焊后冷却时间，以改善钎焊质量的建议。
|
| 关 键 词： | 磷脱氧铜 钎焊 漏气 氢脆 |
| 文章编号： | 1001-4012（2006）02-0092-03 |
| 收稿时间： | 2005-06-30 |
| 修稿时间： | 2005-06-30 |
CRACKING ANALYSIS OF BRAZED PHOSPHORUS DEOXIDIZED COPPER TUBE |
| |
| JIA Yan-lin,WANG Ming-pu,LI Zhou. CRACKING ANALYSIS OF BRAZED PHOSPHORUS DEOXIDIZED COPPER TUBE[J]. Physical Testing and Chemical Analysis Part A:Physical Testing, 2006, 42(2): 92-94 |
| |
| Authors: | JIA Yan-lin WANG Ming-pu LI Zhou |
| |
| Affiliation: | School of Material Science and Engineering, Central South University, Changsha 410083, China |
| |
| Abstract: | The gas leakage failure of braze welding between the phosphorus deoxidized copper tube and stock tank of low carbon steel was investigated by means of metallography, SEM and EDAX analysis. Results show that the brittle fracture is mainly caused by hydrogen brittleness that results from the oxidation and absorbing hydrogen of copper tube during braze welding. Methods of brazing quality improvement are suggested as well. |
| |
| Keywords: | Phosphorus deoxidized copper Braze welding Gas leakage Hydrogen brittleness |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
