Cold and hot rolling of iron powder

Conclusions A BPMF atomized iron powder heated for 20 min at a temperature of 800, 900, 1000, or 1100°C is still characterized by good flowability, readily descends into the region of deformation, and can be rolled into strip. At a temperature above 1100°C this powder sinters into a bar, and can no longer be rolled. The mechanical properties of hot-rolled strips are an order higher than those of cold-rolled ones. Even so, the mechanical properties of strips produced by the hot rolling of the powder under the conditions of the experiments described are inferior to those of P/M parts shaped at room temperature and sintered under optimum conditions. In experiments on the hot rolling of powders between rolls with plain barrels it has proved impossible, because of axial splitting and edge cracking, to obtain nonporous strip of width up to 60 mm. The hot rolling of powders into narrow strips should be performed in closed passes; to reduce the cost of rolls, wide strips should be rolled hot between plain roll barrels, and their edges should then be trimmed.Translated from Poroshkovaya Metallurgiya, No. 10(226), pp. 13–18, October, 1981.