Mechanical properties of textile-inserted PP/PP knitted composites using injection–compression molding

This paper concentrates on the experimental investigation of the self-reinforced all-polypropylene composites. There exists an optimum processing condition to produce high quality specimens by injection–compression molding. Tensile and 3-point bending properties of the virgin PP materials were nearly unaffected by the introduction of reinforcing knit layer(s) due to very low fibre content of the knitted fabrics used. 3-point bending properties were also unaffected by the surface of indentation-flexure. The applied impact energy was maintained at 5 J for the homo-PP and 27 J for the block-PP materials, respectively, to cause penetration during drop-weight impact tests. It is interestingly noteworthy that the self-reinforced homo-PP composites exhibited superior energy absorption capability when compared with the virgin matrix materials. The corresponding plate bending performances of the self-reinforced homo-PP composites also revealed consistent improvement as compared to their virgin counterparts. On the other hand, although virgin block-PP material exhibited better impact performances than its composite reinforced by the homo-PP knitted fabric, a notably small increase in the reinforcement fibre content revealed considerable improvement in the impact properties comparable to those of the virgin block-PP matrix materials. These self-reinforced homo-PP/block-PP materials have clearly indicated that they have the potential to out-perform the block-PP materials via modification and/or manipulation of the reinforcement knit structural/geometrical parameters and the content of reinforcement fibres. Both static and dynamic impact properties are likely to be affected by the local area properties of the tested face under indentation, and thereby contributing to the improved performances of the composite specimens with the knit face under the impact.