Non-destructive Inspection of Adhesively-bonded Joints

The objective of any system of non-destructively examining an adhesive joint must be to obtain a direct correlation between the strength of the joint and some mechanical, physical or chemical parameter which can readily be measured without causing damage. Faults or defects are defined as anything which adversely affect the short or long term strength of a joint. There are two basic areas for examination, the cohesive strength of the polymeric adhesive, and the adhesive strength of the bond between polymer and substrate.

Adhesive strength is very difficult to measure since it is an interfacial phenomenon involving a very thin layer of material, thin even in comparison with bond-line dimensions. Effectively, it would be necessary to assess intermolecular forces and this is not readily possible with existing techniques. This aspect of quality control is usually reduced to assessing the nature of the adherend surfaces prior to bonding.

The cohesive strength of the adhesive is really the only parameter which can be estimated with any degree of confidence, and it is this which features most on destructive tests of bonded joints.

In this paper, defects including porosity, surface un-bonds, zero-volume unbonds, poor cure and so on are discussed, together with the various methods currently used (and some new methods) for physical non-destructive testing.