首页 | 本学科首页   官方微博 | 高级检索  
     

脉冲激光烧蚀沉积ZnSe薄膜的研究
引用本文:许宁,李富铭,Boo Bong-Hyung,Lee Jea-Kuang,Cho Han-Joung. 脉冲激光烧蚀沉积ZnSe薄膜的研究[J]. 中国激光, 2001, 28(7): 661-663
作者姓名:许宁  李富铭  Boo Bong-Hyung  Lee Jea-Kuang  Cho Han-Joung
作者单位:复旦大学光科学工程系三束材料改性国家重点实验室!上海200433,复旦大学光科学工程系三束材料改性国家重点实验室!上海200433,DepartmentofChemistry!ChungnamNationalUniversity,Taejon305764,KoreaandCenterforMolecularScience,3711KusungdongYusunggu,Taejon305701,Korea,D
基金项目:国家自然科学青年基金 (编号 :6970 60 0 1)资助项目
摘    要:用 2 48nm的KrF准分子脉冲激光烧蚀ZnSe靶材沉积ZnSe薄膜。靶采用多晶ZnSe片 ,衬底采用抛光GaAs(10 0 )。衬底预处理采用化学刻蚀和高温处理。原子力显微镜 (AFM )观察显示在GaAs(10 0 )沉积的ZnSe薄膜的平均粗糙度为 3~ 4nm。X射线衍射 (XRD)结果表明ZnSe薄膜 (4 0 0 )峰的半高宽 (FWHM)为 0 4°~ 0 5°。对激光烧蚀团束的四极质谱分析表明烧蚀团束主要由Zn ,Se和 2Se组成 ,并由此推断ZnSe薄膜的二维生长模式。

关 键 词:激光烧蚀  ZnSe薄膜  二维生长模式
收稿时间:2000-04-03

Pulsed Laser Ablation Deposition of Crystalline ZnSe Thin Films
XU Ning LI Fu ming. Pulsed Laser Ablation Deposition of Crystalline ZnSe Thin Films[J]. Chinese Journal of Lasers, 2001, 28(7): 661-663
Authors:XU Ning LI Fu ming
Abstract:Crystalline ZnSe thin films have been deposited on polished GaAs(100) substrates by pulsed laser ablation of a single target of polycrystalline ZnSe solid using KrF 248 nm excimer laser. Chemical etching and high temperature heating were used for pretreatment of substrates. Atomic force microscopy (AFM) shows that the average roughnesses of ZnSe thin films can reach 3~4 nm. X ray diffraction (XRD) shows that FWHM of ZnSe (400) peaks are 0.4°~0.5°. Analysis of quadruple mass spectroscopy for laser ablated plumes indicates that the plumes consist of Zn, Se and 2Se. It was deduced that ZnSe thin film was grown in two dimensional mode.
Keywords:laser ablation   ZnSe thin film   two dimensional mode
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号