Influence of Atomizing Gases on the Oxide-Film Morphology and Thickness of Aluminum Powders

Fine powders of aluminum were produced in a pilot-plant, inert-gas atomizerwith a confined-design nozzle, which operated vertically upward. Argonand helium at 1.85 MPa and nitrogen at 1.56 MPa were used as the atomizingagent. The morphology of the powder particles was examined by SEM. Powderswere sieved dry and wet. The Sauter mean diameter of the powders varied from20.70 to 10.25 m depending on the atomizing gas. The distribution ofsizes was bimodal. The mean thickness of oxide on the surface of the powderwas calculated from the total oxygen contents of powder samples (determinedby a Leco analyzer). In addition, ESCA measurements and BET tests werecarried out for surface-oxide thickness and area measurements,respectively. The finest powder produced under helium incorporated thinnersurface-oxide layers than the coarser ones produced under argon andnitrogen. This was due to differences in physical properties (such asdensity, thermal conductivity) and flow properties (such as gasvelocity and relative velocity) of the atomizing gases used, i.e., helium,argon, and nitrogen. The oxide was very irregular in thickness in thecoarse-size range of the Al powders produced under argon and nitrogen. Thiswas presumably because of the high- and low-temperature oxidation ofaluminum droplets during the atomization and subsequent solidification andcooling periods leading to the rough surfaces observed with SEMinvestigation in the present work.