| 铸铁与铌丝原位生成NbC_P/Fe复合材料 |
| |
| 引用本文： | 刘晓洁,许云华,赵显鹏,牛立斌. 铸铁与铌丝原位生成NbC_P/Fe复合材料[J]. 热加工工艺, 2010, 39(6) |
| |
| 作者姓名： | 刘晓洁 许云华 赵显鹏 牛立斌 |
| |
| 作者单位： | 1. 西安建筑科技大学,机电工程学院耐磨材料研究所,陕西,西安,710055
2. 南京钢铁股份有限公司,中厚板卷厂,江苏,南京,210035 |
| |
| 基金项目： | 陕西省2007年"13115"科技创新工程工程技术中心资助项目 |
| |
| 摘 要： | 利用铸铁浇注将Nb丝均匀复合固定于铁基体内.然后在1165℃保温2h,让提前置于铸铁中的铌丝与周围碳原子原位反应生成NbC颗粒增强铸铁复合材料,对复合区进行显微组织观察分析、显微硬度测量.结果表明,复合区域显微硬度最高值达到1930HV0.05,复合区域的平均显微硬度为1827HV0.05,是基材的8～9倍.复合试样的室温两体磨料相对耐磨性是铸铁的2.71倍,耐磨性能良好.
|
| 关 键 词： | 原位生成 颗粒增强 复合材料 |
NbC_P/Fe Composites In-situ Synthesized by Reaction Between Cast Iron and Nb Wires |
| |
| LIU Xiaojie,XU Yunhua,ZHAO Xianpeng,NIU Libin. NbC_P/Fe Composites In-situ Synthesized by Reaction Between Cast Iron and Nb Wires[J]. Hot Working Technology, 2010, 39(6) |
| |
| Authors: | LIU Xiaojie XU Yunhua ZHAO Xianpeng NIU Libin |
| |
| Abstract: | The NbC_P reinforced cast iron composite was prepared using in-situ reaction between cast iron and Nb wires at 1164 ℃ for 1 h. The Nb wires were uniformly fixed in the iron matrix through pouring molten iron. The microstmcture and microhardness in the compound region were observed and measured, respectively. The results show that, the maximal rnicrohardness in the compound region is 1930 HV0.05, and the average mierohardness is 8～9 times as high as iron matrix. The wear-resistance of the composite is 2.71 times higher than the cast iron standard sample. |
| |
| Keywords: | NbC in-situ synthesis NbC particulates reinforcement composites |
| 本文献已被 万方数据 等数据库收录！ |
|
