Studies of the orientations of fracture surfaces produced in austenitic stainless steels by stress-corrosion cracking and hydrogen embrittlement

Orientation studies have been made on several different austenitic stainless steels, using photogrammetric and electron channeling techniques. The fracture facets produced by SCC in boiling aqueous MgCl₂ (155 °C) were large and relatively flat in the case of type 310 steels, and the fracture plane was found to be at or near {100}. The transgranular stress-corrosion fractures in type 304 steels were more complex, and there was considerably more scatter in the orientation determinations. However, the orientations of the fracture facets in these steels were clearly not {100}, but fell into two distributions, one near {211} and the other near {110}. Electron diffraction studies from the fracture surfaces indicated the presence of α′ and martensites in the type 304 but not in the type 310 cases; the possibility that this was responsible for the differences in fracture planes is discussed. Studies were also made of a type 304 specimen which had failed by SCC at 289 °C. No martensitic phases were detected at the fracture surfaces in this case, and the fracture facets were large and flat, similar to those for type 310. Cleavage-like fracture surfaces were also produced in type 304 steels by hydrogen embrittlement, using both gaseous hydrogen and cathodic charging, but the facets were too small for precise orientation determination. Formerly with the Department of Metallurgy, University of Illinois at Urbana-Champaign. Formerly with the Department of Metallurgy, University of Illinois at Urbana-Champaign. Formerly Professor of Metallurgy, University of Illinois.