| 基于ARM9的嵌入式数控系统的设计 |
| |
| 引用本文： | 朱建富,戴国洪,施卫.基于ARM9的嵌入式数控系统的设计[J].机械设计与制造,2012(3):34-36. |
| |
| 作者姓名： | 朱建富 戴国洪 施卫 |
| |
| 作者单位： | 1. 常州大学机械工程学院,常州,213016
2. 江苏技术师范学院机械与汽车工程学院,常州,213001 |
| |
| 基金项目： | 江苏省高校科研成果产业化推进工程项目(JH10-51) |
| |
| 摘 要： | 对传统的数控系统进行了比较与研究,发现传统的数控系统硬件大多数基于工业控制器之上,分析了基于一般工业控制器的传统数控系统的缺陷,提出了一种基于ARM9微处理器为核心的嵌入式数控系统.该嵌入式数控系统以ARM9微处理器作为硬件平台,采用Windows CE5.0作为操作系统,利用Embedded Visual C++在Windows CE5.0系统平台上开发用户所需程序.系统较好地弥补了传统数控系统的局限性,大大降低了成本,系统能可靠地实时地进行多任务处理,同时由于采用了硬件插补代替了传统的软件插补,提高了加工表面质量.
|
| 关 键 词： | ARM9 嵌入式 Window CE5.0 数控系统 |
The design of embedded NC system based on the ARM9 |
| |
| ZHU Jian-fu
,
DAI Guo-hong
,
SHI Wei.The design of embedded NC system based on the ARM9[J].Machinery Design & Manufacture,2012(3):34-36. |
| |
| Authors: | ZHU Jian-fu DAI Guo-hong SHI Wei |
| |
| Affiliation: | 1College of Mechanical Engineering,Changzhou University,Changzhou 213016,China)(2College of Mechanical and Automobile Engineering,Jiangsu Teachers University of Technology,Changzhou 213001,China) |
| |
| Abstract: | The traditional NC system are compared and research,found that most of the traditional NC system based on industrial controller hardware.on the hardware.The defects of traditional NC system based on the general industrial controller are analyzed.An embedded NC system based on ARM9 microprocessor as the core is presented.This embedded NC system which is based on ARM9 processor as hardware platform and used Windows CE5.0 as operating system.By using Embedded Visual C++ to develop user required procedures on Windows CE5.0 system platform.The limitations of traditional NC system are better compensated by this system.The system can reduce the cost greatly.Meanwhile,multitasks can be real-time and reliable to deal with.Owing to the using of hardware interpolation instead of the traditional software interpolation,the processing surface quality has been improved. |
| |
| Keywords: | ARM9 Embedded Window CE5 0 NC system |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
