Shrinkage in extruded moisture crosslinked silane‐grafted polyethylene wire insulation

Shrinkage studies were conducted on silane‐grafted moisture crosslinkable linear low‐density polyethylene (LLDPE) insulation stripped from extrusion‐coated copper conductors. The insulation, which possesses orientation imparted during melt processing, showed remarkable levels of shrinkage when heated above the melting point of the polymer, though the shrinkage can be greatly reduced by moisture crosslinking the insulation below the melting point of the LLDPE. Shrinkage along the direction of orientation was accompanied by swelling in the other dimensions. Differential scanning calorimetry (DSC) revealed several trends, including a decrease in both melting point and degree of crystallinity with increasing crosslinking. In the first heat after annealing, crosslinked samples exhibited a shoulder in the DSC endotherm several degrees below the normal melting point of the LLDPE. In agreement with prior studies in silane‐grafted HDPE, relaxation of orientation by annealing appeared to result in an increase in the enthalpy of melting. The degree of shrinkage was also found to be dependent on the insulation thickness, which is attributed to faster cooling in thinner insulation immediately following extrusion coating. The results highlight the extensive built in stresses that can be frozen into polymer layers in fabricated articles due to melt orientation. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010