| 注射模结构分析中模型简化的研究 |
| |
| 引用本文： | 廖宇航,李庆,黄志高,周华民. 注射模结构分析中模型简化的研究[J]. 模具工业, 2013, 0(5): 40-43,47 |
| |
| 作者姓名： | 廖宇航 李庆 黄志高 周华民 |
| |
| 作者单位： | 华中科技大学 材料成形与模具技术国家重点实验室,湖北 武汉 430074 |
| |
| 基金项目： | 国家科技支撑计划项目（2011BAF16801）;广东省教育部产学研结合项目（20118090400368）. |
| |
| 摘 要： | 提出了注射模结构分析模型的简化规则,利用正交试验法分析了模具3种大尺寸特征导向部件、浇注系统、冷却系统对模具变形分析的影响,并进行试验验证,确定了最优的注射模结构简化方案。
|
| 关 键 词： | 注射模 模型简化 结构分析 |
Model simplification in injection mould structure analysis |
| |
| LIAO Yu-hang,LI Qing,HUANG Zhi-gao,ZHOU Hua-min. Model simplification in injection mould structure analysis[J]. Die & Mould Industry, 2013, 0(5): 40-43,47 |
| |
| Authors: | LIAO Yu-hang LI Qing HUANG Zhi-gao ZHOU Hua-min |
| |
| Affiliation: | (State Key Laboratory of Material Processing and Die ＆ Mould Technology, Huazhong University of Science ＆ Technology, Wuhan, Hubei 430074, China) |
| |
| Abstract: | The simplification criteria of the structural analysis model for injection mould were proposed. Using the orthogonal experiment method, the effect of three largescale fea tures, namely, guide component, gating system and cooling system, on mould deformation was analyzed. An experiment was carried out to verify the analysis model and the opti mum simplification model was determined. |
| |
| Keywords: | injection mould model simplification structural analysis |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
