| 基于翘曲的注塑工艺优化与均值估计 |
| |
| 引用本文： | 季正伟,张益华,徐成.基于翘曲的注塑工艺优化与均值估计[J].工程塑料应用,2009,37(1). |
| |
| 作者姓名： | 季正伟 张益华 徐成 |
| |
| 作者单位： | 1. 南京航空航天大学机电学院,南京,210016
2. 南京凯盛水泥技术工程有限公司,南京,210036 |
| |
| 摘 要： | 运用MPI软件对所选塑料件在预先设定的各种注射成型工艺参数下进行CAE模拟仿真.利用TaguchiL27(3 13)正交实验表进行试验计划设计,并记录塑料件的最大翘曲量作为数据处理对象.最后对所得翘曲量进行相关统计学分析,得出各种工艺参数组合下最大翘曲量的置信区间及工艺参数的最佳组合,为下一步模具设计和注塑工艺设计提供计算和实验依据.
|
| 关 键 词： | 正交实验 注射成型 最佳工艺组合 |
THE OPTMZATON OF NJECTON PROCESS AND THE ESTMATON OF AVERAGE VALUE BASED ON THE WARP |
| |
| Ji Zhengwei,Zhang Yihua,Xu Cheng.THE OPTMZATON OF NJECTON PROCESS AND THE ESTMATON OF AVERAGE VALUE BASED ON THE WARP[J].Engineering Plastics Application,2009,37(1). |
| |
| Authors: | Ji Zhengwei Zhang Yihua Xu Cheng |
| |
| Affiliation: | College of Mechanical and Electrical Engineering;Nanjing University of Aeronautics and Astronautics;Nanjing 210016;China;Nanjing Triumph Cement Technology Engineering Co.Ltd.;Nanjing 210036;China |
| |
| Abstract: | By useing the software MPI,the CAE simulation on the plastic products with the injection molding process parameters which had been set beforehand was done.The Taguchi L27(313) experiment table was served as the guidance of experiment plan,and the highest warp value of plastic products was recorded as the data process object.Finally,through analyzing the warp value with statistic method,the best injection process combination and the biggest warp confidence interval were obtained,that provided calculating bas... |
| |
| Keywords: | CAE |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
