Macro-porous dolomite hollow fibers sintered at different temperatures toward widened applications

Ceramic hollow fibers from natural dolomite with different pore structures have been designed. The unique hollow fibers were produced by the phase inversion method and applying different sintering temperatures. The hollow fiber precursor presented coagulated polymers through the fiber thickness due to the high granulometric size of the used dolomite material (11.3–47.2 µm). The fiber sintered at 400 °C presented mechanical strength of 4.5 MPa and water permeability of 84.7 L h^?1 m^?2 kPa^?1. The increase in the sintering temperature up to 1250 °C resulted in fragile hollow fibers due to dolomite transformations that resulted in gas release and a significant mass loss of 33.7%. At 1350 °C, the liquid phase sintering mechanism occurred and the dolomite hollow fiber sintered at 1350 °C presented mechanical strength of 5.5 MPa and water permeability of 2219 L h^?1 m^?2 kPa^?1. Doloma dissolution in water was investigated and calcium concentration was increased from 0.72 (pure water) to 2.905 ppm for a contact time from 4 h between the fiber sintered at 1250 °C and pure water. However, this dissolution did not decrease the mechanical resistance of the fiber. These results suggest the potential of applying natural dolomite for producing low cost membranes or substrates. The hollow fiber sintered at 400 °C is suggested to be used as a proper separation medium, while the hollow fiber sintered at 1350 °C may be used as a substrate for the deposition of a separation layer to be used in gas separations. The high porosity of the fiber sintered at 1250 °C suggests its application as a support for the impregnation of functional materials. Thus, depending on the applied sintering temperature the dolomite membrane can be used in different applications.