首页 | 本学科首页   官方微博 | 高级检索  
     

基于驱替定量表征的高含水油田注水井分层配注量确定方法
引用本文:孙召勃,李云鹏,贾晓飞,李彦来,张国浩. 基于驱替定量表征的高含水油田注水井分层配注量确定方法[J]. 石油钻探技术, 2018, 46(2): 87-91. DOI: 10.11911/syztjs.2018027
作者姓名:孙召勃  李云鹏  贾晓飞  李彦来  张国浩
作者单位:中海石油(中国)有限公司天津分公司, 天津 300459
基金项目:"十三五"国家科技重大专项"渤海油田加密调整及提高采收率油藏工程技术示范"(编号:2016ZX05058001)资助。
摘    要:多层合采油藏进入高含水期之后,由于层间驱替程度差异加大,导致常用分层配注方法的效果变差。为此,在分析多层合采油藏长期注水开发特点的基础上,提出采用驱替通量定量表征各层驱替程度差异的方法,并以均衡驱替为目标,综合考虑储层厚度、孔隙度、注水历史、调控周期等因素的影响,建立了基于驱替通量均衡化思想的注水井纵向各层配注量确定方法。运用精细油藏数值模拟方法分析了厚度法、地层系数法、剩余油法和基于驱替定量表征的均衡驱替方法在不同含水阶段的适应性。数值模拟结果显示,含水率小于50%时,推荐采用厚度法;含水率为50%~80%时,推荐采用剩余油法;含水率为80%~90%时,推荐采用均衡驱替法。渤海SZ油田X1井组在高含水期采用均衡法调整配注量,调整后井组平均含水率下降4%,日增油117 m3,降水增油效果显著。研究结果表明,基于驱替定量表征的分层配注量确定方法可用于指导高含水期多层合采油藏注水井各层配注量的调整。 

关 键 词:高含水油田   分层配注   驱替通量   均衡驱替   适应性分析
收稿时间:2017-11-04

A Method to Determine the Layered Injection Allocation Rates for Water Injection Wells in High Water Cut Oilfield Based on Displacement Quantitative Characterization
Affiliation:Tianjin Branch of CNOOC Ltd., Tianjin, 300459, China
Abstract:After reservoirs with multi-layer commingled production enter the high water cut stage,the interlayer displacement disparity is increased and the effect of commonly used layered injection allocation method is deteriorated.Through the analysis of the characteristics of long-term water flooding in reservoirs,a quantitative characterization method using displacement flux to describe the displacement disparity among each layer was put forward.Aiming at balancing the displacement,a new method was established to determine the injection allocation rates for water injection wells based on the idea of displacement flux balance,which took into consideration the influence of reservoir thickness,porosity,water injection history and adjustment cycle.The fine reservoir numerical simulation technique was used to analyze the adaptability of thickness method,formation coefficient method,remaining oil method and the new method at different water cut stages.Numerical simulation results showed that the thickness method is to be recommended when the water cut is less than 50%.When the water cut is from 50% to 80%,the remaining oil method is recommended,and when the water cut is in the range of 80%-90%,the new method can be recommended.The new method was applied to the well group X1 in the Bohai SZ Oilfield as the pilot test and had significant effect,with the average water cut decreased by 4% and daily oil production increased by 117 m3.The research results indicated that the new layered injection allocation method with displacement quantitative characterization could be effective in guiding the optimization and adjustment of the allocations rates in reservoirs under high water cut stage. 
Keywords:
本文献已被 CNKI 等数据库收录!
点击此处可从《石油钻探技术》浏览原始摘要信息
点击此处可从《石油钻探技术》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号